It is found that the speed of air compressor motor is proportional to the actual consumed power of the air compressor. Therefore, it is necessary to reduce the motor speed in order to reduce the actual consumption of the air compressor. The use of VFD in air compressor system can realize the real time control of motor speed (output power) without changing the air compressor motor torque through the accurate coordination of electrical control and frequency control in the air compressor system. To change the compressor speed to respond to the system pressure changes and to maintain stable system pressure can realize the output of high quality air pressure according to demand.
2018, March
When a current spike or voltage surge suddenly occurs in an electrical circuit or a communication line due to external interference like lightning, surge protection device (SPD) can conduct the shunt in a very short time, thereby avoiding the damage of the surge to other equipment in the circuit. It is an indispensable device for lightning protection in the electronic equipment. But some people are still wondering why we need it, or whether need it when we have other lightning protection device? The following FAQ will give your answer for "Why you need a surge protection device".
In the actual use of some low pressure and medium pressure piston type portable air compressor, the two stage compression is often used. The intermediate cooler is set. After the cooling of high temperature air discharged from single stage compression, it is then inhaled into two stage cylinder for two stage compression so as to reach the required pressure. Adopt two stage compression, because if use single stage compression to obtain higher air pressure, the pressure ratio (the ratio of the exhaust pressure and suction pressure) is too large, so that the compression process.
In practical application, after human body intrudes into the range of safety light curtain, besides that safety light curtain needs certain response time, the machine also needs certain braking time. Therefore, to guarantee personal safety of operators, installation position of safety light curtain must meet requirements of safety distance. Otherwise, there is still the possibility of an accident.
Generally speaking, one of the commonly used methods to achieve precise linear positioning is to make a set of linear positioning system by pairing the motor with the sliding bar. Here we will discuss several different ways to create a linear actuator by using the sliding bar and stepper motor. The stepper motor is the most commonly used selection in the application of motor control because if the operation is correct, it is an economic solution that can achieve accurate positioning without the need of position feedback.
Stepper linear actuator can be divided into three types, external shaft type, non-captive shaft type and captive type.
All electrical equipments have their rated power. It is called overload when they surpass the rated power, and protection to the status is called overload protection. Protection to prevent internal short circuit of electrical equipment is called short circuit protection and zero-pressure is also called no-voltage protection. When there is power failure, circuit with the functions mentioned above will stop automatically and electric equipment will not start automatically when power is supplied next time. the purpose of the function is to prevent operating personnel forget cut off power source when there is power failure and electric equipment operate automatically next time when there is power and thus cause accidents. General contractor-controlled circuit has this function.
- 2026
- 2025
- 2024
- 2023
- 2022
- 2021
- 2020
- 2019
- 2018
- 2017
- 2016
- 2015
- 2014
- 2013
- 2012