60 hp (45 kW) high quality variable frequency drive, three phase 240V, 380V, 480V for selection, IP20.
Specification:
| Basics | Model | GK3000-4T0450G/ GK3000-2T0450G |
| Capacity | 60 hp (45 kW) | |
| Shipping weight | 31 kg | |
| Dimension | 555*310*260 mm for GK3000-4T0450G/ 650*400*300 for GK3000-2T0450G | |
| I/O Feature | Rated current | 91A at 380V ~ 480V, 176A at 220V ~ 240V |
| Input voltage | 3 phase 240V /380V /480V AC ±15% (Optional) | |
| Input frequency | 50Hz/ 60Hz | |
| Output voltage | 3 phase AC 0~input voltage | |
| Output frequency | 0Hz~1000Hz | |
| Over load capacity | 150% of rated current for 1 minute, 180% of rated current for 3 seconds | |
| Control Feature | Control mode | V/F control; Sensorless vector control; |
| Communication | RS485 | |
| Speed regulation | 1:100 | |
| Start torque | 150% of rating torque at 1 Hz | |
| Speed control accuracy | ≤±0.5% of rating synchronous speed | |
| Frequency precision | Digital setting: max frequency x± 0.01%; Analog setting: max frequency x± 0.2% | |
| Frequency resolution | Analog setting: 0.1% of max frequency; Digital setting: 0.01Hz | |
| Torque boost | Automatic torque boost, manual torque boost 0.1%~30.0% | |
| Interior PID controller | Be convenient to make closed-loop system | |
| Automatic energy save running | Optimize V/F curve automatically based on the load to realize power save running | |
| Automatic voltage regulation (AVR) | Can keep constant output voltage when power source voltage varies. | |
| Automatic current limiting | Limit running current automatically to avoid frequent over-current which will cause trip | |
| Environment | Enclosure rating | IP 20 |
| Temperature | –10℃~ +40℃; VFD will be derated if ambient temperature exceed 40℃; each rise 1℃, the derate will be 5% | |
| Humidity | 5%-95%, without condensation | |
| Altitude | ≤1000m; VFD will be derated if above 1000m | |
| Impingement and oscillation | Normal running:<5.9m/s2 (0.6g); Transportation:<15m/s2 (1.5g) | |
| Store environment | –20℃~ +60℃; no dust, no corrosive gas, no direct sunlight |
Note: ATO VFD Cannot be used as a power source, it Can only be directly connected to an induction motor to control the motor speed.
Tips: Variable frequency drive storage notifications
If the VFD is not used for long periods of time, it may be damaged, which is caused by the environmental conditions that do not meet the storage conditions of the VFD. Therefore, the VFD should be placed in the packing case when stored, and note the following:
- It is the best to store in absence of sun, no dust and dry place.
- The ambient temperature is best in the range of -20~40℃.
- The relative humidity is best in the range of 20% to 90%, without condensation.
- Avoid long-term storage in corrosive gases and liquids environment.
- Long term storage (2-3 years) will lead to electrolytic capacitor degradation. Adding voltage can self-repair certain degree of deterioration. In long-term storage, it should be regularly (within 6 months) powered on for at least 5 hours, and the input voltage should be gradually raised to the rated value by voltage regulator. If the storage period is more than 10 years, the electrolytic capacitors rubber sealed will lose efficacy and must be replaced.
Product reviews
Motor shaft voltage
Guest
6/5/2017 8:05 PM
In my option, it depends on the horsepower of the motor. The costs of motor under 60 hp doesn't not justify insulating either bearing. 75 hp (360 frames) to the end of t frames roughly 250 hp in a 4 pole, i would just insulating one bearing. Everything after t frames I would insulate both bearing if being used on a VFD. After 2000 hp I would insulate and add a shaft grounding ring for insurance. The level of protection must be weighted against how critical the motor is, and the costs of the protection versus the costs of replacement/time to reorder.
Was this review helpful? (0/0)
VFD heat generation
Vered
3/17/2025 7:17 PM
What is the heat generation of this VFD?
Was this review helpful? (0/0)
Only registered users can write reviews
Customers who bought this item also bought
40 hp (30 kW) VFD, 3 Phase 230V, 420V, 480V
GK3000-4T0300G
$1,497.31
High quality 40 hp (30 kW) VFD with low cost, three phase 230V, 420V, 480V variable frequency drive with good performance, brand new direct sale by manufacturer.