50 kvar Shunt Power Capacitor, 3 phase, 450V, Self-healing

$344.54
The 3 phase power shunt capacitor is installed at low voltage electrical system in parallel for improving power factor and self-healing performance of electrical power. 50 kvar rating capacity, can be used in 50Hz or 60Hz, 450V AC circuit system.
SKU: ATO-CAP-45050
Free Shipping
Delivery date: 6-12 days

50 kvar Shunt Capacitor Features

  • 3 phase, 50 kvar rating work at 450V AC low voltage.
  • Small volume, light weight and easy to install.
  • Excellent self-healing performance: When a part of the isolation is fed through due to the over voltage, it is capable of self-healing so as to continue the operation.
  • With the actual loss less than 0.1, little radiation, low temperature rise, and good energy conservation effect.

50 kvar Power Capacitor Specifications

Model0.45-50-3
ShapeRectangular
Weight6 Kg
Height330 mm
Rated Voltage450V AC
Rated Capacity50 kvar (786 μF)
Rated Current64.2 A
Rated Frequency50Hz or 60Hz
Capacity Tolerance-5%~+10%
Outgoing TerminalM8
Connection3 line-△ type / 4 line-Y type
Anti Voltage
  1. Between two pole 2.15 times rated voltage is 10s;
  2. Between two pole 3 kv please choose highest value 10s;
  3. There is noperpetuity puncture and flash over.
Max Permit Over Voltage
  1. 1.1 times rated voltage, the high permit over voltage is not more than 8 hours within 24 hours.
  2. 1.15 times rated voltage, it is not more than 30 minutes within 24 hours.
  3. 1.2 times rated voltage, it is not more than 5 minutes.
  4. 1.3 times ratedvoltage, it would not more than 1 minute.
Max Permit Over CurrentIt is permit that the over current is not more than 1.3 times rated current.
SafetySelf healing, Sheet metal enclosure
CertificationGB/T 12747-2004, IEC60831: 212002

Note: Need more models information of the 3 phase shunt capacitors, please click here.

Capacitor Installation and Dimension (mm)

capacitor dimensionTips: Discharging device for shunt power capacitor

The shunt power capacitor is under energy storage condition when it is put into operation. When it is disconnected from the power supply, there is still a certain amount of energy stored, and there is a certain residual voltage between the electrodes of capacitor. This energy cannot be discharged to a safe voltage in a short time by its resistance with high insulation. If the capacitor is switched to run again when there is still some charges in capacitor, a strong impact switching-on inrush current and high overvoltage will be produced, which will cause electric damage if one contacts with a capacitor that still has some residual charges , so it is necessary to equip with special discharging device.

When the capacitor is removed from power grid, perform discharging completely by discharging device. The residual charges on capacitor should be removed within prescribed period of time and make the residual voltage on capacitor reduce to specified safe voltage (75V), so as not to cause personal and equipment accident. For low-voltage capacitors, resistance in series should be adapt while the discharging coil as discharging device should be adapt for the high-voltage capacitors. Sometimes, the transformer or distribution transformer primary winding of single-phase triangular wiring or the open triangular wiring can be used as discharging coils.

In this video, ATO will show you three phase parallel capacitors / self-healing.

Product reviews
50kvar shunt power capacitor has good self repair function
5
Bowler
Avatar
3/25/2021 2:54 AM
I saw the description on the product page that this 50kvar shunt power capacitor has excellent self healing performance. I didn't hesitate to buy it as soon as I saw this, and it met my expectations.
Was this review helpful? Yes No (0/0)
Good 50 kvar shunt power capacitor
5
Judel
Avatar
4/29/2021 2:33 AM
Can you provide 50kVAR, 3-phase, 240V shunt power capacitor?
Was this review helpful? Yes No (0/0)
ATO Responded
No, can not provide. For 3ph, 240V voltage, the maximum capacity can be 30KVAR.
Write your review
  • Only registered users can write reviews
*
*
  • Bad
  • Excellent
*
*
*
*

50 kvar Shunt Capacitor Features

  • 3 phase, 50 kvar rating work at 450V AC low voltage.
  • Small volume, light weight and easy to install.
  • Excellent self-healing performance: When a part of the isolation is fed through due to the over voltage, it is capable of self-healing so as to continue the operation.
  • With the actual loss less than 0.1, little radiation, low temperature rise, and good energy conservation effect.

50 kvar Power Capacitor Specifications

Model0.45-50-3
ShapeRectangular
Weight6 Kg
Height330 mm
Rated Voltage450V AC
Rated Capacity50 kvar (786 μF)
Rated Current64.2 A
Rated Frequency50Hz or 60Hz
Capacity Tolerance-5%~+10%
Outgoing TerminalM8
Connection3 line-△ type / 4 line-Y type
Anti Voltage
  1. Between two pole 2.15 times rated voltage is 10s;
  2. Between two pole 3 kv please choose highest value 10s;
  3. There is noperpetuity puncture and flash over.
Max Permit Over Voltage
  1. 1.1 times rated voltage, the high permit over voltage is not more than 8 hours within 24 hours.
  2. 1.15 times rated voltage, it is not more than 30 minutes within 24 hours.
  3. 1.2 times rated voltage, it is not more than 5 minutes.
  4. 1.3 times ratedvoltage, it would not more than 1 minute.
Max Permit Over CurrentIt is permit that the over current is not more than 1.3 times rated current.
SafetySelf healing, Sheet metal enclosure
CertificationGB/T 12747-2004, IEC60831: 212002

Note: Need more models information of the 3 phase shunt capacitors, please click here.

Capacitor Installation and Dimension (mm)

capacitor dimensionTips: Discharging device for shunt power capacitor

The shunt power capacitor is under energy storage condition when it is put into operation. When it is disconnected from the power supply, there is still a certain amount of energy stored, and there is a certain residual voltage between the electrodes of capacitor. This energy cannot be discharged to a safe voltage in a short time by its resistance with high insulation. If the capacitor is switched to run again when there is still some charges in capacitor, a strong impact switching-on inrush current and high overvoltage will be produced, which will cause electric damage if one contacts with a capacitor that still has some residual charges , so it is necessary to equip with special discharging device.

When the capacitor is removed from power grid, perform discharging completely by discharging device. The residual charges on capacitor should be removed within prescribed period of time and make the residual voltage on capacitor reduce to specified safe voltage (75V), so as not to cause personal and equipment accident. For low-voltage capacitors, resistance in series should be adapt while the discharging coil as discharging device should be adapt for the high-voltage capacitors. Sometimes, the transformer or distribution transformer primary winding of single-phase triangular wiring or the open triangular wiring can be used as discharging coils.

Product reviews
50kvar shunt power capacitor has good self repair function
5
Bowler
Avatar
3/25/2021 2:54 AM
I saw the description on the product page that this 50kvar shunt power capacitor has excellent self healing performance. I didn't hesitate to buy it as soon as I saw this, and it met my expectations.
Was this review helpful? Yes No (0/0)
Good 50 kvar shunt power capacitor
5
Judel
Avatar
4/29/2021 2:33 AM
Can you provide 50kVAR, 3-phase, 240V shunt power capacitor?
Was this review helpful? Yes No (0/0)
ATO Responded
No, can not provide. For 3ph, 240V voltage, the maximum capacity can be 30KVAR.
Only registered users can write reviews